Couldnt load arm9 payload...

Discussion in '3DS - Flashcards & Custom Firmwares' started by Zalg0, Jan 30, 2017.

  1. Zalg0
    OP

    Zalg0 Member

    Newcomer
    21
    1
    Feb 9, 2016
    United States
    Trying to install this over my rxtools and followed all the steps here https://3ds.guide/installing-arm9loaderhax until the end of SECTION IV where I ran into the black screen error. I now followed the steps on here https://3ds.guide/9.2.0-ctrtransfer Until the end of SECTION III where now it says "Err: Couldnt load arm9 payload press any button to continue..." when I try to boot up. and when I try to click any button it doesnt do anything.

    This is just for my SYSnand btw..when I hold L for EMUnand to boot up it does and im in "EMU 11.2"
     
  2. thisisallowed

    thisisallowed 中国御宅族

    Member
    595
    136
    Oct 8, 2015
    China
    Jinan, Shandong
  3. Ar5chK3ks

    Ar5chK3ks GBAtemp Regular

    Member
    132
    14
    Mar 14, 2016
    Gambia, The
    To give a bit more context to the link above my post:
    You can just move your EmuNAND to your SysNAND if it is on 11.2.
    This will make you able to skip the update Step since you are on the latest firmware already.
    After that you can just continue the guide like before and finish the setup.
     
    Quantumcat likes this.
  4. Zalg0
    OP

    Zalg0 Member

    Newcomer
    21
    1
    Feb 9, 2016
    United States
    Thank you guys so much. I must have backed up a million times only to realize I was being stupid and not backing up in the correct.bin's it wanted me to. It all works now.