Hacking Changing Emunand filesystem

[GardenAll]

Hello guys, I have an original 4.1.0 Switch and have been using it with sysnand CFW and AutoRCM. I decided to rollback to it's original firmware and start a emunand CFW to play it safer. But as you know, 4.1.0 only accepts FAT32 and I really would like to run this emunand in ExFat.
Is it possible to:

• Install the CFW in FAT32 on an lower capacity SD
• Install the lastest firmware by emunand on the same SD
• Transfer all the emunand content to a ExFat SD and run it with no problems
• ???

 

[BaamAlex]

exFAT causes definitely data corruption. I don't understand why you want to use it. Stay at fat32.

Transfer all the emunand content to a ExFat SD and run it with no problems

This makes no sense. All the contents from the fat32 card are splitted. They are smaller as 4gb.

 

[annson24]

Hello guys, I have an original 4.1.0 Switch and have been using it with sysnand CFW and AutoRCM. I decided to rollback to it's original firmware and start a emunand CFW to play it safer. But as you know, 4.1.0 only accepts FAT32 and I really would like to run this emunand in ExFat.
Is it possible to:

• Install the CFW in FAT32 on an lower capacity SD
• Install the lastest firmware by emunand on the same SD
• Transfer all the emunand content to a ExFat SD and run it with no problems
• ???

You can have an emunand/emummc with fat32.

Sent from my SM-N975F using Tapatalk

 

[Draxzelex]

Hello guys, I have an original 4.1.0 Switch and have been using it with sysnand CFW and AutoRCM. I decided to rollback to it's original firmware and start a emunand CFW to play it safer. But as you know, 4.1.0 only accepts FAT32 and I really would like to run this emunand in ExFat.
Is it possible to:

• Install the CFW in FAT32 on an lower capacity SD
• Install the lastest firmware by emunand on the same SD
• Transfer all the emunand content to a ExFat SD and run it with no problems
• ???

All firmware versions accept FAT32 and exFAT except 1.0 which doesn't support exFAT.