Hacking Question Black screen, don't boot nor detect payload

[Immubach]

>> ISSUE SOLVED <<

Hi guys!

I think i'd messed it up someway and i dont find any thread which give me some solution. If you can help me, i would thank you a lot.

My switch was in 5.1.0 CFW, 1.7.1 Reinx (sd files from sdsetup), autoRcm enabled, and I decided to update to 6.1.0 using ChoiDujour and following the SdSetup Guide to update. No wild issues appeared while updating. After the installation, i pressed Reboot and then Shutdown now.

Black screen of autoRCM, so i inyected the payload through TegraRcmGui as always. It detected the autoRcm mode, that green icon you know. The switch booted, the Reinx logo showed and then the nintendo logo. After that, was an endless black screen. I was puzzled so I tried a second payload inyect. It detected the autorcm, inyect, some flash and ... black screen. Reinx logo didnt appear

Now, the green icon in Tegra doesnt appear. Press the Power button dont work. The only thing i didnt try is to use a Jig (the one i used was lent by a friend)

Any ideas?

PD: i am 100% sure the switch didnt run out battery

 

[DestructiveSword]

Try holding down the power button for about 15 seconds then just inject a normal payload.

 

[rodan100919]

Is your SD exFAT or FAT32? I had a similar issue when trying to use exFAT. Would inject ReiNX fine, get the Nintendo/Switch logos, but no boot. Turns out the SD corruption bug would actually mess with the ReiNX files, so doing a clean install and moving to FAT32 fixed the issue in my case.

 

[Immubach]

Issue solved! Yesterday i put in the sd the latest nightly Reinx version and today used a jig + tegra payload.

Thanks for your answers guys! ^^