Hacking 6.2.0 Nand Dump not loading while 3.0.0 Nand dump does

[Agent Moose]

System: non-patched Switch 3.0.0 OFW Kosmos v13

So I was trying out EmuMMC and I ran into a problem: My Switch loads my 3.0.0 firmware just fine (both on Sys and Emu) but my switch will not load my 6.2.0 nand dump on either Sysnand or Emunand. The Kosmos loading screen just sits there.

Anyone have any ideas on how to fix this?

 

[Fuzzy-v]

I have the same issue, boot logo crashing on 6.20. Apparently it's a bug in Atmos 0.9.2 or in Hekate 5.0. Hasn't heard for sure which one is the cause but I suspect it's Hekate, because if I use fusee I can boot Atmos.

I guess versions 5.00, 6.01 and 6.20 are currently affected, rendering backups useless right now. Good that 3.XX works as my first backup is a 3.XX.

 

[Agent Moose]

I have the same issue, boot logo crashing on 6.20. Apparently it's a bug in Atmos 0.9.2 or in Hekate 5.0. Hasn't heard for sure which one is the cause but I suspect it's Hekate, because if I use fusee I can boot Atmos.

I guess versions 5.00, 6.01 and 6.20 are currently affected, rendering backups useless right now. Good that 3.XX works as my first backup is a 3.XX.

You can use fusee to load 6.2.0? I've always used Hekate, is there anything different to do when loading with fusee-payload?