3ds clk solder

Discussion in '3DS - Flashcards & Custom Firmwares' started by Darkrevol, Jan 28, 2014.

  1. Darkrevol
    OP

    Darkrevol Member

    Newcomer
    1
    Jan 27, 2014
    France
    hello, my clk point is breaked can i dump my nand without it or other clk?
     
  2. Gadorach

    Gadorach Electronics Engineering Technologist

    Member
    6
    Jan 22, 2014
    Canada
    Canada
    You need to repair the SPI/SD clock signal point for it to work properly I believe. If you do not have the required skills to repair this point, I strongly suggest that you take it to a local electronics repair shop to avoid further damage.
     
  3. Darkrevol
    OP

    Darkrevol Member

    Newcomer
    1
    Jan 27, 2014
    France
    thank you and with what type of material i can repair it?
     
  4. Gadorach

    Gadorach Electronics Engineering Technologist

    Member
    6
    Jan 22, 2014
    Canada
    Canada
    Assuming the point is a VIA, you'd need a piece of Kynar (30AWG solid core) wire to fit into the hole. Otherwise, it would just take a light repair of the same wire to reconnect the two sides of the traces connected to the test point. As I don't know exactly what it looks like off hand, I can't provide exact instructions, but it should be similar to any standard trace repair.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice