Hardware 2DS Hardmod Problem

[Jeff Sakamoto]

Soldering the wires are done and i already check for any short circuit and there's no shorted from my solders. after i checked the soldered wires i put all the necessary ribons to it's places and screwed back the cover. after that i check the 2ds for power and there's the light for the power. so i turn it off. and when i proceed to install the sd card to the card reader and to the computer there's no power or any output from the 2ds.

what is my problem?

 

[proflayton123]

@gamesquest1 @vb_encryption_vb

 

[Boogieboo6]

I don't know anything about hardmodding, but I know you're going to have to post pictures of your work.

 

[vb_encryption_vb]

So you try to power on the 3ds and it don't power on?

 

[Deleted User]

Maybe it does power on, check the ribbon cables to the screen. Also make sure the contacts from the power button work right.

 

[Jeff Sakamoto]

Maybe it does power on, check the ribbon cables to the screen. Also make sure the contacts from the power button work right.

its ok and checked triple times on first try its sucess to power on but when tried to put in sd card reader the 2ds wont turn on even all wirings removed

--------------------- MERGED ---------------------------

So you try to power on the 3ds and it don't power on?

yes 2ds sir on first try without sdcard reader plug in works well but when tried on pc with card reader since then 2ds wont turn on

 

[vb_encryption_vb]

Battery might nit be making proper contact.

 

[Jeff Sakamoto]

Battery might nit be making proper contact.

no problem on battery because we removed all the wiring and back to normal but no luck on powering on

 

[Deleted User]

Battery might nit be making proper contact.

I agree! The battery may have kinda been a bit loose if you did a permanent badly wired hardmod.

 

[vb_encryption_vb]

Check for solder splashes, cut ribbins, etc.

 

[Jeff Sakamoto]

Check for solder splashes, cut ribbins, etc.

we checked already

--------------------- MERGED ---------------------------

any suggestion

 

[gamesquest1]

if you left a blob of solder on the back of the board it could be shorting on the screen, you also may have broken the sleep switch

 

[Jeff Sakamoto]

if you left a blob of solder on the back of the board it could be shorting on the screen, you also may have broken the sleep switch

thanks for your suggestions but in first try we successfully powered on and we tried in pc we got that problem

 

[Jeff Sakamoto]

help

 

[gamesquest1]

you could check the fuses I guess they will be marked F1 and F2 and one will be near the battery and one near the charging port

 

[Jeff Sakamoto]

you could check the fuses I guess they will be marked F1 and F2 and one will be near the battery and one near the charging port

will try sir thanks

 

[Jeff Sakamoto]

more suggestion plsss

 

[Deleted User]

You can always just buy a new one. I think the MarioKart bundle comes on 6.9, 6.3 etc. You can just use Decrypt/Hourglass9 to do a NAND dump and if anything goes wrong where you can't access hourglass just hardmod it to restore the NAND then.