hi guys
i was wondering if you would be able too help me with 2 nsw's i have here.
nsw1 No video output too dock charging ok / dock light is constant green):
Has a lot of shorted caps on the back of the motherboard (back of the tegra chip). Picture is included
I have replaced the p13usb and the usb-c connector. This did not fix the shorts.
Where to look next?
nsw 2: screen doesn't turn on (tried the board in a other switch same problem) :
im nearly sure this is a patched switch unit but serial is possibly patched. It does however have autorcm installed and working.
when i send a payload with tegrarcm (windows) it says it has been send successful.
when i follow this guys great guide:
this site /threads/a-definitive-way-to-test-if-your-switch-is-patched-or-not-purchases-after-07-2018.512018/
i get this answer
0X0000
any advice would be greatly appreciated
i was wondering if you would be able too help me with 2 nsw's i have here.
nsw1 No video output too dock charging ok / dock light is constant green):
Has a lot of shorted caps on the back of the motherboard (back of the tegra chip). Picture is included
I have replaced the p13usb and the usb-c connector. This did not fix the shorts.
Where to look next?
nsw 2: screen doesn't turn on (tried the board in a other switch same problem) :
im nearly sure this is a patched switch unit but serial is possibly patched. It does however have autorcm installed and working.
when i send a payload with tegrarcm (windows) it says it has been send successful.
when i follow this guys great guide:
this site /threads/a-definitive-way-to-test-if-your-switch-is-patched-or-not-purchases-after-07-2018.512018/
i get this answer
0X0000
any advice would be greatly appreciated
