Recent content by maximus007

  1. maximus007

    ps5 error ce-108262-9 uart 80800000

    I'm working on a PS5 which I believe has a failing gddr6 ram ic, the console randomly crashes when launching games or navigating through the menus. is it possible to work out which ram ic is failing from the log below? 01 02/12/2025 14:25:00 80800000 Low Kernel Panic Shutdown...
  2. maximus007

    Ps5 uart code 808300F1

    I'm working on a PS5 slim edm 040 that boots to safe mode / attempts to repair the console storage but hangs at 5 percent and switches off. This is the uart error Unknown - Possible related to Secure Loader Error (Southbridge, APU, SSD) - PlayStation 5 shuts off no warning, message etc...
  3. maximus007

    Hardware PS5 shuts down in 1 to 1,5 hour.

    Try replacing the PSU, if you've cleaned it and don't get the overheating message and it shuts off abruptly the PSU probably isn't supplying enough current. If you have access to a Dc load you can check the PSU.
  4. maximus007

    Hardware Ic identification

    Does anyone know what this IC is, the markings on it are BQ5AP, I'm not getting 5v output from this IC for the disc drive. It has 5v going into it and F5401 is fine.
  5. maximus007

    Hardware Error CE-108255-1 fortnite

    Yes this does have the original firmware, as it's only happening when the game is checking for updates, it leads me to believe the console has been banned or put on a blacklist with the fortnite servers. No UART errors at all.
  6. maximus007

    Hardware Error CE-108255-1 fortnite

    I have a PS5 with a weird problem. When launching Fortnite, it gets to the stage where it's checking for updates then throws the CE-108255-1 error. I've tried everything, factory reset, updated software, rebuilt database...even copied all data from a working console via network onto this (took...
  7. maximus007

    EDM 010 1 beep no lights

    I'm working on an EDM 010 that beeps and shuts off. The URAT output is "80871055 Low SSD Banks IO Error Between SSD Controller" There are no shorts on the board and the voltages from the SSD PMIC are present. However what I did notice is that pin 1 on both these Mosfets has a low...
  8. maximus007

    EMD-020 resistor value

    Thank you
  9. maximus007

    EMD-020 resistor value

    can anyone help with the value of this resistor? I believed there was a short under the southbridge, but after some probing this resistor is connected to the cmos battery, hence it was showing as a short! Resistor went flying never to be found again in the process!
  10. maximus007

    Hardware PS5 stuck in a safe mode boot loop

    The SSD controller finally arrived from AliExpress today, installed it and the ps5 is alive again.
  11. maximus007

    Hardware PS5 stuck in a safe mode boot loop

    The controller is being recognised and when the PS button is pressed, it then goes to the "please wait" screen and stays here for several seconds before it reboots back to the "Connect the controller using the USB cable and then press the PS button." I don't get any opions at all like there...
  12. maximus007

    Hardware PS5 stuck in a safe mode boot loop

    I have a PS5 EDM-020 that's boots straight into safe mode and only gives the option to connect controller via usb. When the PS button is pressed it proceeds to "please wait" then reboots again to the "Connect the controller using the USB cable and then press the PS button." No other options are...
  13. maximus007

    Hardware What's the value of this missing capacitor?

    I've removed the esd IC on this series X as pin 19 on hdmi was shorting, shorts now gone but I've lost the cap on the right What is it's value? Thanks
  14. maximus007

    Hardware EDM-020 no 3.3v or 1.8v

    Yes, I've removed the 4 caps under the WiFi chip, short present. Is it best to tackle the removal of the WiFi chip with heat from top or bottom of PCB?
  15. maximus007

    Hardware EDM-020 no 3.3v or 1.8v

    I've figured it out I think, the 3.3v inductor from the DA9066 supplies the enable pin to both these TPS62822DLCT. The inductor on the TPS62822DLCT that supplies the 1.8v (F7002 side) is shorted, short is not on the TPS62822DLCT side but after the inductor, also shorted caps under the WiFi...
See more