Hacking Question Switch SXOS Autorcm Question

[shanefromoz]

Hello all i have a switch on 10.0.2 and have installed autorcm.
When i turn off the switch completly and turn it on again it will now boot into normal switch menu rather then sxos.
I use SX Tools with my Android phone.
Im using sxos v2.9.5 beta.
I thought once in autorcm mode if i turned it off it would automatically boot back into sxos.
Any ideas? Thanks

 

[LiveMChief]

AutoRCM just prevents the need to use a jig in order to enter RCM for payload injection.

 

[shanefromoz]

AutoRCM just prevents the need to use a jig in order to enter RCM for payload injection.

Even when using my Android phone and SX Tools when restarting the switch goes to normal switch menu rather then sxos

 

[Dust2dust]

So autoRCM is not enabled, after all. Boot in RCM mode normally (with a jig) and try enabling autoRCM again.

edit: are you sure you're not booting in SXOS? It won't boot the menu, normally. Try launching the album.

 

[shanefromoz]

So autoRCM is not enabled, after all. Boot in RCM mode normally (with a jig) and try enabling autoRCM again.

edit: are you sure you're not booting in SXOS? It won't boot the menu, normally. Try launching the album.

Autorcm is enabled. I then turn off switch. I turn on again using Android phone and SX Tools and it loads into normal switch menu not sxos.
I am sure its a bug.

 

[shanefromoz]

Can anyone please suggest how i can fix this issue. Thanks

 

[xabier]

Can anyone please suggest how i can fix this issue. Thanks

Press the volume+key when you load the payload to go into sx boot menu, try to load sx os from there, you could even load hekate and check if works.

 

[shanefromoz]

Press the volume+key when you load the payload to go into sx boot menu, try to load sx os from there, you could even load hekate and check if works.

I understand that. But when in autorcm there should be no need for the jig.
For some reason all of a sudden i need to put in jig and hol volume + even with autorcm activated

 

[xabier]

I understand that. But when in autorcm there should be no need for the jig.
For some reason all of a sudden i need to put in jig and hol volume + even with autorcm activated

You dont need the jig to load sx menu, when sx payload is loaded(with or withouth a jig), when you inject the payload and boot press vol+, it will take you to sx menu.

 

[shanefromoz]

You dont need the jig to load sx menu, when sx payload is loaded(with or withouth a jig), when you inject the payload and boot press vol+, it will take you to sx menu.

I understand that.
What i am saying is when i have autorcm activated and turn off my switch i should be able to load payload with sx tool and sx will load.
Currently this is not happening.
I then need to use jig again.
I believe this is a bug.

 

[xabier]

I understand that.
What i am saying is when i have autorcm activated and turn off my switch i should be able to load payload with sx tool and sx will load.
Currently this is not happening.
I then need to use jig again.
I believe this is a bug.

boot your payload without the jig, press volume+