Hey all,
First things first. I have a jig and can get into RCM 100% of the time. Also, I am 99.9% sure it isn't currently in RCM and I do have autoRCM disabled unless it just magically turned on. Here is where it gets good (not really...) I know that I screwed up so no need to tell me that, but I upgraded my FW through Nintendo and then downgraded with Choi... BUT I always booted into RCM and loaded with Hekate and everything was fine for a couple of day . Last I used it I made sure I powered off my switch and the next time i went to use it, I had my jig in and held the vol up and hit the power button and nothing. Now, my switch wont turn on. Tegra isnt detecting a RCM device. I have more exploitable switches and again, I know my mistake, but I would like to know if my switch is screwed, or if there is a possible solution.
First things first. I have a jig and can get into RCM 100% of the time. Also, I am 99.9% sure it isn't currently in RCM and I do have autoRCM disabled unless it just magically turned on. Here is where it gets good (not really...) I know that I screwed up so no need to tell me that, but I upgraded my FW through Nintendo and then downgraded with Choi... BUT I always booted into RCM and loaded with Hekate and everything was fine for a couple of day . Last I used it I made sure I powered off my switch and the next time i went to use it, I had my jig in and held the vol up and hit the power button and nothing. Now, my switch wont turn on. Tegra isnt detecting a RCM device. I have more exploitable switches and again, I know my mistake, but I would like to know if my switch is screwed, or if there is a possible solution.