I followed the guide but it just will not enter vendor mode when selecting device intro or lite-on erase.
I have the key.bin extracted via my rgh through J runner extract files. The stock pcb and the unlocked one won't enter vendor mode. I tried for a couple hours now and nothing I try will work.
I've tried with my ck3i as well as a x360 usb pro.
Anyone got any ideas? I'm about ready to give up. I've flashed 2 phats and a couple slims before without any issues. This is my first 16D5S though. I think it's MXIC (the one that doesn't involve the kamakazi drilling hack).
Would really appreciate if someone could help out. I'm at a loss here.
Edit - Finally got it to work. Stupid mistake. Apparently you switch power off Before clicking intro then switch back on. I was power cycling after clicking intro the whole time
I have the key.bin extracted via my rgh through J runner extract files. The stock pcb and the unlocked one won't enter vendor mode. I tried for a couple hours now and nothing I try will work.
I've tried with my ck3i as well as a x360 usb pro.
Anyone got any ideas? I'm about ready to give up. I've flashed 2 phats and a couple slims before without any issues. This is my first 16D5S though. I think it's MXIC (the one that doesn't involve the kamakazi drilling hack).
Would really appreciate if someone could help out. I'm at a loss here.
Edit - Finally got it to work. Stupid mistake. Apparently you switch power off Before clicking intro then switch back on. I was power cycling after clicking intro the whole time
Last edited by SmellyPirateMonkey,