Hacking OOT3D exploit problem

[cucho565]

Hi you guys, i was playing perfectly fine with New 3DS on firmaware 9.1 and Gateway 3.4, recently updated to 10.2 but I am unable to run gateway again, try to use the OOT3D but when load the file, the screen freezes and nothing happend, previously when i try it in 9.1 it works fine and allow me to enter the gateway mode but not know, Im doing something wrong, any advised or walkthrough you could share?

Thanks in advance

 

[MissingNO123]

Update your payload.

 

[CrispyYoshi]

Hi you guys, i was playing perfectly fine with New 3DS on firmaware 9.1 and Gateway 3.4, recently updated to 10.2

Wait, why would you update your system past 9.2? Are you referring to emunand? In any case, I agree with the previous poster: You need to update your payload so it works on 10.2.

 

[cucho565]

Thank you for your response, what I mena is that my console was working fine in 9.0 with Gateway buy when i borrow it they play Mario an Luigi Paper Jam with an original card and updated the system to 10.2, thats why im trying to make gateway work again, already try with the OOT3D but the screen freezes , so how can i make it work again?

 

[Temarile]

Thank you for your response, what I mena is that my console was working fine in 9.0 with Gateway buy when i borrow it they play Mario an Luigi Paper Jam with an original card and updated the system to 10.2, thats why im trying to make gateway work again, already try with the OOT3D but the screen freezes , so how can i make it work again?

Gateway only works up to 9.2 (until they release 10.3 support which is supposedly going out on the 22nd of may) and for OOThax you need to adjust your payload to the firmware you're currently on. You had a save file with a 9.2 payload and now you need a 10.2 payload. You can find them on the oothax page.

 

[cucho565]

F*#k, thats why it doesnt work anymore, so hopefully on 22nd of may will make it work again, thanks for the infor,ation Temarile!!!

 

[Temarile]

F*#k, thats why it doesnt work anymore, so hopefully on 22nd of may will make it work again, thanks for the infor,ation Temarile!!!

Even so, you can always use the browser (browser hax) to launch the homebrew channel and then use the oothax exploit installer there to get to correct payload for 10.2, if you have OoT as a physical cartridge that is. Once you've done that, you can run pliasysupdater to downgrade to 9.2 again

 

[cucho565]

Thank you for the tip, will try it later, have a good weekend.