Hacking DSTTi bricked

[Gambit_G]

I've got a DSTTi card which I attempted to update with TTi143UPGRADE.nds. Unfortunately it got stuck at 0.78% and unsurprisingly after 10 mins when I switched it off / back on again it's now not showing up as a DS card. I have a DSTT card that is working fine. Is there any way I can reflash the DSTTi card using the DSTT card to load the source files and then flash to the DSTTi? I know this has been asked before but I can't see an answer to the "Can a DSTT card be used to start the reflash" question. Thanks.

 

[akari212]

maybe you can recover it via Slot-2 NDS mode.

just a random guess, but i did tried it recovering my DSTTi clone from brick

 

[jimmyemunoz]

Go here to the sixth post. You can use the DSTT and the unbricker v1.01 Make sure you use the Homebrew Menu (another download) to boot up the unbricker.

 

[Gambit_G]

Thanks for the info but I must be missing something. Running the unbricker on the DSTT on a DS lite (launched from the homebrew menu) and hot swap to the DSTTi card but then get "Your bricked firmware card HD=0, Your bricked firmware=0, This unbricker can't run on a DSi or 3DS or your card is bad. Shutdown". How can the EZ flash unbricker unbrick a DSTTi card?

 

[Mbmax]

Thanks for the info but I must be missing something. Running the unbricker on the DSTT on a DS lite (launched from the homebrew menu) and hot swap to the DSTTi card but then get "Your bricked firmware card HD=0, Your bricked firmware=0, This unbricker can't run on a DSi or 3DS or your card is bad. Shutdown". How can the EZ flash unbricker unbrick a DSTTi card?

It can't, don't use it. This unbricker was made for the ez5i hardware only.

 

[Gambit_G]

Not going mad then :-) Any other thoughts on how I can unbrick a DSTTi with just a DSTT?

 

[bitonio6]

I've got a DSTTi card which I attempted to update with TTi143UPGRADE.nds. Unfortunately it got stuck at 0.78% and unsurprisingly after 10 mins when I switched it off / back on again it's now not showing up as a DS card. I have a DSTT card that is working fine. Is there any way I can reflash the DSTTi card using the DSTT card to load the source files and then flash to the DSTTi? I know this has been asked before but I can't see an answer to the "Can a DSTT card be used to start the reflash" question. Thanks.

It's because your DSTTi was not an 100% genuine! So now you need to buy another flashcard !

it exist no solution to save a DSTTi original (or not), bricked!