Switch lite rp2040 chip readings

[Joe714]

Hi everyone I’m doing my first mod on switch lite with rp2040 zero when I turn it on I get blue light then *== *== *== yellow/green
Another noob question do you need to insert the Sd card with what ever files on it for it to boot to hekate or should it boot just with mod chip? Thanks in advance

 

[SylverReZ]

Hi everyone I’m doing my first mod on switch lite with rp2040 zero when I turn it on I get blue light then *== *== *== yellow/green

I would check your soldering connections for CMD, CLK and a few other points using a multi-meter.

 

[Joe714]

I would check your soldering connections for CMD, CLK and a few other points using a multi-meter.

This is the readings I get

 

[SylverReZ]

This is the readings I get

When you test the points, you should hear a beep meaning that it was connected. Judging by the 'G' point (supposedly 'GND'), its possible that it wasn't connected properly.

 

[Joe714]

When you test the points, you should hear a beep meaning that it was connected. Judging by the 'G' point (supposedly 'GND'), its possible that it wasn't connected properly.

I just marked it as G but it is grounded to a cap