Picofly XLL help needed

[DIGNAMPETER]

Hi folks,

NOOB here but this community is amazing. I have installed picofly XLL (Tiiny orange one, can't seem to upload pics yet) . Anyway Yekaterinburg working , cfw working but won't boot emunand. Getting a pkg1 and HOS error. No matter how many cards formatted and used with new emmc setup. Can anyone help?
All points have been soldered correctly. Using HATS 16.0.2 ABD FIRMWARE 16.1

 

[Deleted member 681324]

Get the latest Hekate from gjthub

 

[DIGNAMPETER]

Hi, thanks for your help , iv tried that. Just wondering , I did read that the data line could need a 100ohm resistor but that was another chip. Do you think this also needs that?
Appreciate the help

 

[Deleted member 681324]

Well, you're getting software errors with the pkg1 error you mentioned. That's why my presumption is your files on your SD.

 

[DIGNAMPETER]

Well, you're getting software errors with the pkg1 error you mentioned. That's why my presumption is your files on your SD.

Iv tried several cards and always used HATS pack. Funny thing is sysnand works no problem. When I try boot into OFW from Hekate I just get a blank screen .

 

[Deleted member 681324]

Bypass modchip with vol + & - then power

 

[DIGNAMPETER]

Bypass modchip with vol + & - then power

ok finally got it to mwork. The SD card type is very important and after several times i bought a 128gb card and it all worked!! Thank ytou for all your help!!