So, I am trying to homebrew friend 2DS. I am having problems to get the homebrew on my other 2DS. So please watch the video and tell me what I did wrong!
I only watched up to the ~1 min mark. Why did you use restore flash on the R4i Gold Plus? You have an internal toggle switch that you can open up the cart and change into NTRBoot. Restore Flash returns the cart into a working DS flashcart, this will not allow it do the magnethax.
Make shure the pink 3ds is reading the r4 card properly.
If it was then it wouldnt of gave your b9s 3ds any trouble the first time launching the b9s installer.Apparently your 3ds's have some wear and tear on the 3ds card reader or the card itself isnt communicating to the 3ds correctly.So, I can't NTRBoot anymore?
I had to or else it wouldn't allow me to launch it.
--------------------- MERGED ---------------------------
It is
If it was then it wouldnt of gave your b9s 3ds any trouble the first time launching the b9s installer.Apparently your 3ds's have some wear and tear on the 3ds card reader or the card itself isnt communicating to the 3ds correctly.
So, I can't NTRBoot anymore?
the r4i gold 3ds plus has a switch internally to switch it from ds to ntrboot but you flashed the ds part so its now strictly an ntrboot cart and once its flashed (not appearing on home menu) you dont need to do the flashing part for another systemSo, I can't NTRBoot anymore?
I had to or else it wouldn't allow me to launch it.
--------------------- MERGED ---------------------------
It is
--------------------- MERGED ---------------------------
Do I have to do inject NTRBoot function?
The R4i Gold Plus is a special flashcart that holds two (2x) NANDs unlike its older predecessor, the R4i Gold 3DS RTS [which has only one (1x) NAND]. There was no need to flash NTRBoot onto your cart because it already had it installed on one of those NANDs. All you have to do is open the cart up and flip the toggle switch to the NTRBoot option. Flip it back to DS flashcart after you're done hacking.
You didn't do anything fatal or commit a permanent mistaken that isn't fixable. Just make sure you have the [DS mode NAND] flashed with the R4i Gold 3DS RTS firmware and the [NTRBoot NAND] flashed with the NTRBoot. If you have either switched around or both with NTRBoot -or- stock firmware, just reflash them back accordingly.
How do I reflash them back?
After getting the flashbacks. What do I do? All I see is backup.bin. The page doesn't show how to reflash.Refer to this thread in how to open up your flashcart.
[Review] R4i Gold 3DS Plus
While you're toggle switch is at the D position (which is the arbitrary chosen NAND for DS flashcart mode), use the Restore Flash option that you did in the video to put the stock R4i Gold 3DS RTS firmware back onto that NAND if it isn't there already.
Switch it the N position when you're ready to use NTRBootHax. If you happen to have messed up and flashed the stock firmware onto the N-side NAND, just go through the motion of reflashing it back to NTRBoot firmware.
Yes. All the buttons work. I gtg for nowDid you make sure to rename SafeB9SInstaller.firm to boot.firm? Try using tape to hold the (Power) + (Start) + (Select) + (X) buttons when you switch it into sleep mode. Just keep holding it until it boots.
Edit : I kept watching and got to the 8 min mark. OKAY, so your flashcart is fine. Files on the SD card is fine. The problem would be the button combo step.
Edit #2 : Can you verify that the pink 2DS has each button working, the least obvious being the (Select)?
Yes. All the buttons work. I gtg for now