What connectors did you use? I would like to do a clean install exactly like that.
looks like a 4pin fan header connector with some parts filled off.
What connectors did you use? I would like to do a clean install exactly like that.
What connectors did you use? I would like to do a clean install exactly like that.
looks like a 4pin fan header connector with some parts filled off.
Actually it is a board to board connector at 1.27mm pitch, this is the one I use of a board to board connector from Newark. It is slightly shaved down because the adapter board I made was using the wrong thickness FR4.
Thank you all! I will keep you informed of my project
Not that I know of, sorry. I hope someone finds it ^^But for the CLK on N3DS (non XL)? Nothing yet?
seriously nice work, i'd pay to have you do mine.
During the xl modding, I found that my sd reader isn't maybe compatible with these new models, even if it works great with the old ones. So, maybe the right clk point was already discovered initially, but without the right sd reader or/and a logic state analyzer I could not detect it. Now I have just ordered a Transcend, like the same in your first post.Not that I know of, sorry. I hope someone finds it ^^
During the xl modding, I found that my sd reader isn't maybe compatible with these new models, even if it works great with the old ones. So, maybe the right clk point was already discovered initially, but without the right sd reader or/and a logic state analyzer I could not detect it. Now I have just ordered a Transcend, like the same in your first post.
So, I repeat, perhaps the clk mentioned in 3dbrew is right. If someone can test and dump, we will have the confirmation.
Unfortunately I don't have anymore the n3ds non xl.
today or tomorrow arrive me the pieces for my mod (n3ds no xl), i will report
EDIT: A question. does someone has been reading and writing NAND? i dont see nothing photo