Homebrew Question Wireless Update problem

[DonRamon]

Hello guys, have a problem at hand and need a little info

Got my Switch (homebrewed with SXOs) borrowed to a friend for a tournament, and, he needed a wireless play with two consoles, both homebrewed with SXOs

The thing is, since the games were not in the same version, he did the "wireless" update from console to console, with his console on 6.2, and mine on 6.0

The good thing is that we both use emunand, but, in the end of the proccess, things got a little weird with the console´s booting (got lot slower) and the system, in fact, got into 6.2 firmware, but, since I use emunand, I at least don´t think the fuses got burned (I still have the normal nand on 4.1, and could boot it with no problems... burned fuses there would result in a brick, right?)

But the real thing now is:

1 - I lost the SDXC (EXFAT) support... how can I install that one again only?
2 - I still have a backup of my old 6.0 update with the EXFAT support included and can install it with ChoiDujour... would be easier (and safe) to just downgrade to get things back the way it was?

3 - I think the problem is that the installation wasn´t complete with the whole rebooting consoles and such, would be better to re-install 6.2 update with ChoiDuJour on top of this one (don´t even know if this is possible)


Please, need a little help here cause I don´t know if this was a bad mistake he did with my Switch and, as said, need to re-gain the EXFAT support for the bigger games

Thank you all for the attention on this!

 

[shado9573]

Why Don't you update using ChoiDujourNX and enable ExFat support to get your firmware to 6.2.
You can use the old update (assuming fuses were not burned) but however ust on to 6.2. It has CFW and every CFW is supporte just make sure no accidents happen and it gets updated to 7.0.0. If you using EmuNAND just update both to the same version and then try it. and make sure to reinstall properly. Otherwise use Backups to restore and do this.

 

[DonRamon]

Why Don't you update using ChoiDujourNX and enable ExFat support to get your firmware to 6.2.
You can use the old update (assuming fuses were not burned) but however ust on to 6.2. It has CFW and every CFW is supporte just make sure no accidents happen and it gets updated to 7.0.0. If you using EmuNAND just update both to the same version and then try it. and make sure to reinstall properly. Otherwise use Backups to restore and do this.

Many thanks! Will try to re-install 6.2 then with ChoiDujour and see if it gets the EXFAT option on the program

The reason I think fuses weren´t burn is because when the update finished on the wireless communication, it re-started the console, but, since I use emunand, it started on the original nand, which is on 4.1, and, since it still on this very same firmware and accessible, I think fuses were not burn since it would lead into a brick

Just let me know if anyone got na extra info on this and if I need to be worried, but, in the overal, yes, will try to re-install 6.2 then and see if it Works!

 

[shado9573]

Make sure AUTORCM is on. That prevents burning fuses.
You can also refer to this guide over here.
https://gbatemp.net/threads/how-to-...nofficially-without-burning-any-fuses.507461/