will modded boot without this connection?

[Fede12]

Post automatically merged: Aug 28, 2024

i burnt it cuz im stupid

 

[Deleted member 681324]

... OLED? I've not done one, but if it's only connecting points on the mobo you could use wire in place of that ribbon flex cable... just match letter (point) to letter (modchip).

 

[Fede12]

... OLED? I've not done one, but if it's only connecting points on the mobo you could use wire in place of that ribbon flex cable... just match letter (point) to letter (modchip).

its not a point used in any video

 

[Deleted member 681324]

Is that ribbon cable from a modchip kit? May have to use wire in place of the ribbon cable if it's not functioning properly without burnt connection... or maybe try scrape trace to connect to cap/resistor...

 

[alecocr20]

Hello,
That is only an anchor point to hold the flex cable more solidly, so the flex is still fully fonctional. There are two important points A and D and there are still there. Don't forget to use low heat, I use 650.

 

[jkyoho]

that point is connected to ground, as long as you have other ground pad having connection.(i.e the pad under label A) you are good

 

[Fede12]

Hello,
That is only an anchor point to hold the flex cable more solidly, so the flex is still fully fonctional. There are two important points A and D and there are still there. Don't forget to use low heat, I use 650.

okay thanks