USB Loader 2 Installations Help

Discussion in 'Wii - Backup Loaders' started by wiiBug, May 27, 2011.

  1. wiiBug
    OP

    wiiBug Newbie

    Newcomer
    1
    May 27, 2011
    I have installed homebrew/BootMii on a 4.3E system as an IOS, then downgraded to 4.1 as I heard that 4.3E was not compatible , have loaded USB Loader GX 2 as a channel ok but when I try and use it, it will go back to the main Wii Menu after a few seconds.

    Is there anything else I need to install, have read on this forum about IOS58, CIOS 249, Hermes cIOS's Wainkoko cIOS-X and would it be ok to upgrade to 4.3E again to use wii fit, MotionPlus, balance Board etc?

    I only want to use the Homebrew as a loader to store our games etc, not bothered about any other homebrew application

    Thanks
     
  2. Porobu

    Porobu Gbatemps Shiny Latias

    Member
    3
    Sep 12, 2009
    Use ModMii to hack your wii saying its a virgin and to set up a usb loader
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice