Hardware Update Fake Pro Controller?

[Noble77]

I recently bought a fake pro controller to use as a coop controller but I've been having an issue with the joysticks where it doesn't register being fully to the upper right and lower right until I reset it to factory settings. It's really annoying to have to reset each joystick to factory settings every time I wake up the switch so I was wondering if there is a way to update it or is there any other way it can be fixed?

Yes, I'm aware that this is expected with a cheap clone controller but I'd still like to now if there is any possible solutions to fixing it other than buying an actual pro controller or another clone controller.

 

[kiairii]

I bought a decent fake off of aliexpress, no issues where did you buy yours?

 

[Shadow#1]

I recently bought a fake pro controller to use as a coop controller but I've been having an issue with the joysticks where it doesn't register being fully to the upper right and lower right until I reset it to factory settings. It's really annoying to have to reset each joystick to factory settings every time I wake up the switch so I was wondering if there is a way to update it or is there any other way it can be fixed?

Yes, I'm aware that this is expected with a cheap clone controller but I'd still like to now if there is any possible solutions to fixing it other than buying an actual pro controller or another clone controller.

No there is no other solution then buying official

 

[R3D_Klone]

Have you tried replacing the analogue sticks and seeing if it’s a sensor issue?
How is memory of calibration saved on cheaper controllers?

 

[Shadow#1]

Have you tried replacing the analogue sticks and seeing if it’s a sensor issue?
How is memory of calibration saved on cheaper controllers?

It's not saved

 

[R3D_Klone]

It's not saved

If it’s not saved, it’s possibly an easy fix just by swapping rockers then, right? Not a hard experiment if he has wick, flux, an iron, and experience