Hacking Udsploit Not launching the CTRT screen

[Galerox]

I'm following the guide to downgrade the console , the firmware is 10.0.0.33 U if I'm not mistaken.

I launched the udsploit and it says that it was successful

But It doesn't launch the screent of the CTRTransfer

The last 2 lines of the message are:
patching krneT... done !
00000000

Is it normal? Can I continue with the guide and manually open the CTRT ?

 

[rikumax25!]

you need to boot safehax after that

 

[Galerox]

Indeed that was the solution, shame on me and bless this place because the people is extremely torelant

 

[The Real Jdbye]

Indeed that was the solution, shame on me and bless this place because the people is extremely torelant

That's not always the case. There are copious amounts of shitposting and flaming in this section.

 

[Distrance]

I was mildly confused in that step too, simply because the screen doesn't say anything after that. It'd be nice if the dev of udsploit could add a line where it said "Press Start to go back" when the exploit is finished.

 

[Majickhat55]

Or.... People could just read directions Lol.