Switch not turning on

[zumbito]

So after a failed Picofly install, I decided to remove the flex cables, resulting in the switch not turning on. A couple caps from the APU disappeared in the process of removing the cable and habe orders some.
While I wait for the caps to be delivered, any tips of where or how to start? Maybe how to find shorts, in case the caps are not the main problem?

 

[thesjaakspoiler]

Check for other missing components and damage to traces on the PCB.

Here is a ton of information on what to expect (although it is for a Switch V1 but a lot of the components are the same).
https://www.retrosix.wiki/full-boot-from-bench-power

 

[zumbito]

Check for other missing components and damage to traces on the PCB.

Here is a ton of information on what to expect (although it is for a Switch V1 but a lot of the components are the same).
https://www.retrosix.wiki/full-boot-from-bench-power

I have only touched three parts, and they all seem fine. This is really nerve wrecking.

 

[Nephiel]

Might be nothing, but I'd look at this trace and check it isn't cut:

Could also be a short in (or around) the kamikaze spot. Other than that, I don't really see anything.