Hi.
I'm following the Switch homebrew guide & succesfully grounded pin 9 & 10. My Switch is in RCM, I installed TegraRCMGUI (my OS is Windows 10) & installed the driver.
Then I connected my Switch to the PC & it's not recognized. The connection sound plays & the switch stays dark, however it says "unknown USB device" & nothing shows up on TegraRcmGUI.
I used a different cable, no changes.
I tried Rekado on my android phone, there the switch doesn't show up at all.
I tried to install libusbK via Zadig, doesn't work either.
I used a different Windows 10 computer, the same issue.
When I connect the Switch in normal mode with the same cables, everything works fine.
What's going on? I'm pretty desperate right now. Should I sell the Switch & buy a new one? Do you have any suggestions?
Help pls!
I'm following the Switch homebrew guide & succesfully grounded pin 9 & 10. My Switch is in RCM, I installed TegraRCMGUI (my OS is Windows 10) & installed the driver.
Then I connected my Switch to the PC & it's not recognized. The connection sound plays & the switch stays dark, however it says "unknown USB device" & nothing shows up on TegraRcmGUI.
I used a different cable, no changes.
I tried Rekado on my android phone, there the switch doesn't show up at all.
I tried to install libusbK via Zadig, doesn't work either.
I used a different Windows 10 computer, the same issue.
When I connect the Switch in normal mode with the same cables, everything works fine.
What's going on? I'm pretty desperate right now. Should I sell the Switch & buy a new one? Do you have any suggestions?
Help pls!