Switch Erista AutoRCM black screen. Help

[monbot]

I have an Erista V1 which i did not completely managed to install CFW on, turned it off without disabling auto RCM. Has not been used for almost 6 months and still turns on into a switch logo then black screen.
Recently i tried to add CFW again but again it only shows the switch logo then goes black. I know that the battery is one of the issue so i changed the battery to a new one (fully charged using my wife's V2) but the console was still not detected by TegraRCM and screen still goes black when turned on. Btw I know that the cable is not the issue because i tested my wife's mariko V2 which gets detected by tegraRCM. Anyone know the issue here?

 

[Gbasam64]

There should be no switch logo when it enters RCM, have you tried it without Joycons attached?

 

[monbot]

There should be no switch logo when it enters RCM, have you tried it without Joycons attached?

Sorry om refering to when turning the console on. The nintendo logo would show up then goes black.

As for during tegraRCM, the console is not detected at all.

 

[Gbasam64]

There should be no switch logo when it enters RCM, have you tried it without Joycons attached?

Sorry om refering to when turning the console on. The nintendo logo would show up then goes black.

As for during tegraRCM, the console is not detected at all.

Yes but what I mean is, there should be no nintendo boot logo, if you start it up, there screen should be black the entire time until it enter RCM. So i don't think it's weird that the tegraRCM doesnt detect anything as it isnt entering RCM proven by the nintendo logo.

 

[monbot]

There should be no switch logo when it enters RCM, have you tried it without Joycons attached?

Yes but what I mean is, there should be no nintendo boot logo, if you start it up, there screen should be black the entire time until it enter RCM. So i don't think it's weird that the tegraRCM doesnt detect anything as it isnt entering RCM proven by the nintendo logo.

So i just tried turning on the console without the joycons. Nintendo logo shows up but then goes to black screen. I dont know what to do from here.

 

[Gbasam64]

So i just tried turning on the console without the joycons. Nintendo logo shows up but then goes to black screen. I dont know what to do from here.

Try entering RCM properly, power off the console. If you are unsure, hold down the power button for a maybe 15-20 seconds.
Then use a jig or whatever you used the first time. hold down + button and press the power button once. You should see no boot logo. If you see the nintendo logo then try again.