Well after evalfile usefulscripts/SetupNew.js, I get this instead of NO OUTPUT, as on video. It seems that nothing is working on my pcin terminal
git clone https://github.com/reswitched/pegaswitch
cd ~/pegaswitch
npm install
sudo node start.js
Well after evalfile usefulscripts/SetupNew.js, I get this instead of NO OUTPUT, as on video. It seems that nothing is working on my pcin terminal
git clone https://github.com/reswitched/pegaswitch
cd ~/pegaswitch
npm install
sudo node start.js

Im not sure, but u didnt must use that command anymore. I everytime skip them and starting from running the ace.
sdbcore is enabled in new pegaswitch by default, so u can skip this too.
im tired and it's hard to explain but I got alot going on i made really dumb mistake and wrote switch ip in my command
Instructions
Load Pegaswitch
Run following in Pegaswitch:
enable sdbcore
evalfile usefulscripts/SetupNew.js
Open 2 cmd promps with Admin rights and enter Bash enter following cmd in one window:
nc -v -l -p 2991
Back to pegaswitch enter:
runnro ./nros/ace.nro
Now use the other terminal window. As in video I recommend cd till you are in your nro folder from here enter:
ncat --send-only 192.168.0.2 2991 < retroarch_switch.nro
Replace my ip with yours.

1. Loaded, waited for "pipe closed",
2. Enabled sdbcore. Recieved: enabled sdbcore
3. After evalfile usefulscripts/SetupNew.js recieving this: View attachment 109775
And after this, there is no reason to continue...
Eh...as others have mentioned you must enable the running of nro I suspect. But I am sorry I have no other ideas. try this will you?
">git pull origin runnro-command
You're welcome"
I hope this helps you...courtesy of FoxofGrey
and on the terminal (ncat -klp 2991) after launch ace.nro, nothing change tooTry again. Its normal.
1. Loaded, waited for "pipe closed",
2. Enabled sdbcore. Recieved: enabled sdbcore
3. After evalfile usefulscripts/SetupNew.js recieving this: View attachment 109775
And after this, there is no reason to continue...
Read the pegaswitch documentation on their githubAfter I write runnro ./nros/ace.nro Pegaswitch terminal write unknown cmd
Do you have the nro for it?see, isn't that hardNew RetroArch support MutliRom etc.
Will try, a little later. I am done for now. Need rest a little.This is clearly an issue with your Nodejs runtime. Before loading pegaswitch, what is the output of node --version ?
I recommend unistalling this nodejs version and installing the latest. Good luck.

@Nezztor Hey, do your emulator have a ROM in it? Just wanted to say, you might want to change the link to exclude it, as distributing ROMs on here is uh, well, kinda bad...?I don't know it was an oversight, and it so that's fine, just be careful
![]()
no one has a problemI was Thinking about that, but this is just a POC but if some mod have a problem with it I will remove the link shure

I was Thinking about that, but this is just a POC but if some mod have a problem with it I will remove the link shure