- Joined
- Feb 1, 2009
- Messages
- 2,359
- Solutions
- 7
- Reaction score
- 366
- Trophies
- 1
- Location
- Shmashmortion Clinic
- XP
- 1,699
- Country

Received my Sinden a few days back and am seriously losing my shit with it. Built an arcade cab and am using a VirtualMan 256gb retro paradise build with a Pi3b. Followed the instructions here https://sindenlightgun.miraheze.org...spberry_Pi_-_How_to_set_up,_run_and_calibrate. but when it comes to running the testp1 bit, I get no white border, nothing responds (can't even exit) just get a message saying "Version 1.6. Only for use with official sinden lightguns". I have to switch off the machine and reboot. I have contacted both sales and tech support but got no reply. I know this is a long shot but does anyone have any ideas? I've followed the process a good 6 times and even wiped the SD card and re-installed the build but can't get past this point.





