simple question about the jig

Discussion in 'Switch - Exploits, Custom Firmwares & Soft Mods' started by calaveragtafallout, Aug 15, 2018.

  1. calaveragtafallout
    OP

    calaveragtafallout Member

    Newcomer
    1
    Aug 13, 2018
    Anguilla
    hi if i put the jig/paperclip and then start rcm mode so that tegrarcmgui recognizes that i'm in rcm mode and i inject a payload (for example the hekate one) then can i remove my jig for example before dumping the nand (so removing it just after hekate launched) thanks
     
  2. rmorris003

    rmorris003 Member

    Newcomer
    4
    Nov 9, 2008
    Canada
    Yes you can remove the jig once the system has booted. A simple search would have gave you the answer.
     
  3. c80

    c80 Banned

    Banned
    2
    Jun 1, 2018
    Germany
    You cannot write rcm mode. You must write RCM. RCM stands for recovery mode so rcm mode is recovery mode mode. That makes no sense! It is a redundant acronym. It is the same mistake as if you would say PIN number, http protocol or HIV virus.
     
    Asia81 likes this.
  4. calaveragtafallout
    OP

    calaveragtafallout Member

    Newcomer
    1
    Aug 13, 2018
    Anguilla
    ok thanks and can i also leave attached my usb cable to the pc during the whole nand backup process so that it can charges?
     
  5. Dave_Chad
    This message by Dave_Chad has been removed from public view by Chary, Aug 15, 2018, Reason: what.
    Aug 15, 2018
  6. Dave_Chad

    Dave_Chad GBAtemp Advanced Fan

    Member
    6
    Jun 29, 2016
    I left it plugged in and it went ok.
     
  7. Dave_Chad

    Dave_Chad GBAtemp Advanced Fan

    Member
    6
    Jun 29, 2016
    I left it plugged in and it went ok.
     
Loading...