Hello guys, this is my first post here! I just got a MIG Switch card out of curiosity and I was tinkering with it. For those who don't know, it's used by placing XCI dumps as well as other game specific bin files in the sd card of the MIG Switch, and are obtained from the original cartridge by using an app like nxdumptool. Two of these bin files are mandatory to get the game to boot: Initial Data.bin and Certificate.bin. They stay the same for every cartridge of a specific game. Now, if you want to use an XCI dump from a shady website it's impossible to get it to work without those files. By using the Certificate.bin from another game it has no problem, but this does not count for the Initial Data.bin. So I looked for a way to obtain this Initial Data from an XCI file and read a bit of the XCI file documentation from switchbrew dot org. Here's what I understood so far: The Switch checks if the cartridge is valid by doing a challenge–response authentication on the Initial Data. The Package ID is contained both on the XCI and the Initial Data, on positions 0x110 and 0x0 respectively. The Initial Data hash is on the XCI at position 0x160. It is calculated by doing a SHA-256 hash on the full Initial Data content. So I was wondering, is there a way to to construct a functional Initial Data file starting from an XCI dump? I also tried a reverse approach by editing the Package ID in the Initial Data from another game, generating the Initial Data hash and putting it in the XCI file but is not enough to get the Switch believe it's a real game. Sorry if this may seem stupid but let me know what you think.

duckstation for Switch

catlover007 · 2024-04-22T04:06:40+00:00

duckstation is an excellent Playstation 1 emulator by Stenzek. It has a very good compabiility and it is quite performant. It also supports all kinds of enhancements such as high resolution rendering and PGXP which can lessen the "wobble" and...

ReLinking account to banned switch?

Kawaiibaby

Active Member

Newcomer

Level 1

Dec 17, 2018

So during the 6.2 update release my fuses were burnt from being updated(not by me). When trying to see how to still use CFW aside from the suggested NAND backup(because mine oddly made a partial back up) it was suggested to try recovery mode. I dumbly followed the advice and it just wiped everything, and of course the update stuck. This unlinked my account as well, and well being already banned I was perfectly fine with never being able to play Splatoon again until buying another switch. That is until LAN play was released, and now when I try to connect it says "Link account", and following ofcourse is the banned message pops up when trying to link one. So close but this is a total block. Mistakes were made. Anyone have a fix to this?
P.S, everything CFW and Lan Play ect is running and set up on 6.2. Nothing is missing but linked account. :switch: