Homebrew problem entering homebrew launcher

[veraci_00]

hello. I'm having an issue entering the homebrew launcher. I'm on firmware 6.2.0-4 btw. whenever I try using browser hax, I get kicked out of the browser with "an error has occurred" the homebrew launcher is on the root of my sd card (32GB) too. I've also tried ninjahax. there's no qr code for my firmware, so I went with what was closest - 6.2.0-7. however, it gets stuck at 70% when trying to launch the exploit. I'm not sure what's going on. any help is appreciated. thanks!

 

[Arubaro]

Using ninjhax you should be able to run hblauncher v1.
Maybe you cannot because you updates using a cartridge?

If you want to use browserhax, you need to be at least on 9.0

 

[Manuel9181]

You should install rxTools and then proceed updating your sysNand to 9.2 fw. Here you can find every info that you need, from the installation to the update.

 

[veraci_00]

I'm stuck at the step where u install big blue menu on system nand. r they talking about the actual system nand or rx system nand? 'cause the normal system nand doesn't override the health and safety icon, but the rx system nand does. do I enter rx system nand to install the sys updater? thanks

 

[samiam144]

I'm stuck at the step where u install big blue menu on system nand. r they talking about the actual system nand or rx system nand? 'cause the normal system nand doesn't override the health and safety icon, but the rx system nand does. do I enter rx system nand to install the sys updater? thanks

rx system nand to install (you need CFW privileges obviously), but use Pasta Mode/Devmode to actually use Sysupdater or you will brick.

 

[Manuel9181]

I'm stuck at the step where u install big blue menu on system nand. r they talking about the actual system nand or rx system nand? 'cause the normal system nand doesn't override the health and safety icon, but the rx system nand does. do I enter rx system nand to install the sys updater? thanks

Download and extract into the root of your SD this version of sysupdater
Download from that ISO site the correct 9.2 fw for your console (double check the region and if it's the o3ds version or the n3ds one)
Extract the .cias of this package into a folder called "updates" placed into the root of your SD
Boot your 3ds and enter into the rxTools' main menu (holding the L buttom while you lauch it)
From there, move to the right until the Advanced Settings' section
Launch DEVMODE/PASTAMODE
run FBI/BBM/DEVmenu and install sysupdater
run sysupdater and proceed with the upgrade

Launching sysUpdater while you are on rxSYSNAND will result in brick, so be sure to be on DEVMODE/PASTAMODE before to launch the upgrade