After successfully completing the installation of the modchip, I accidentally tugged on the Point A cable, while attempting to reattach the cable i heated the resistor too much, and it came off. Look at pictures for reference. I just bought the replacement resistor 0201 4.7k ohms. I was reading this post but, what happens if i cannot successfully attach a new resitor. Also any tips on how i can replace the resistor. I was suggesting using a hot air rework station but I cannot find a small enough nozzle. Here is the old post that guided me.
the second picture, where the resistor is visible is not soldered on. I was attempting to solder it but damaged it in the process. Therefore i purchased new ones.
Post automatically merged:
the second picture, where the resistor is visible is not soldered on. I was attempting to solder it but damaged it in the process. Therefore i purchased new ones.
