Hacking Point A resistor damaged

[Ecastro]

After completing the installation of the modchip, I accidentally tugged on the Point A cable, while attempting to reattach the cable i heated the resistor too much, and it came off. Look at pictures for reference. I just bought the replacement resistor 0201 4.7k ohms. I was reading this post but, what happens if i cannot successfully attach a new resitor. Also any tips on how i can replace the resistor. I was suggesting using a hot air rework station but I cannot find a small enough nozzle. Here is the old post that guided me.

Post automatically merged: Jun 3, 2024

Old Post that guided me “

OLED Switch “A” CMD Resistor - Half Damaged Pad”​

Did not let me post link

 

[jkyoho]

if you have large tip which could melt both top and bottom point, you could just slide new resistor into position when both pads is liquefied