Hardware Only showing Nintendo logo

[Agilato]

Installed rcm and driver, nothing shows up when connecting to the pc.

New to the game, so have no clue if I did it right

Check if console is patched: https://ismyswitchpatched.com/

To put console in RCM mode:

1. Make sure Console is turned off, in your case you can just unplug battery and plug it back or hold power for 8 seconds.
2. Put RCM Jig in right Joy-Con.
3. Hold + AND Press power.

Than if you will plug it to PC TegraRCM should notice it.
But if you loading payload in to the patched version you get black screen.

 

[Inja]

Unpatched device. The ribbon connector for the right joycon on the switch is missing the latch.
Will it work without the latch?

Anyway, got a new battery and installed it. Still same issue.
Waiting for the chips now

 

[Inja]

Check if console is patched: https://ismyswitchpatched.com/

To put console in RCM mode:

1. Make sure Console is turned off, in your case you can just unplug battery and plug it back or hold power for 8 seconds.
2. Put RCM Jig in right Joy-Con.
3. Hold + AND Press power.

Than if you will plug it to PC TegraRCM should notice it.
But if you loading payload in to the patched version you get black screen.

So I managed to get it into RCM mode and its shows text.

Tried loading Atmosphere but after the triangle logo, the switch turns it self off. Just like after showing Nintendo logo

 

[Deleted User]

Did you ever figure this out? I had two that had 0 amps charging and after changing the chips they both do this same thing. Nintendo logo then off. Both charge at .4amps

 

[Agilato]

I also have one switch after water damage, loads Hekate, all stats looks good, but won't load any payloads or regular fw