Hello, I received 3 consoles (OLED switch) from different customers and all 3 have the same problem.
All 3 are unlocked but arrived with problems!
Two of them used HWFLY and it stopped working.
The third one used PICOFLY but it stopped working too.
They were all opened and I checked all the soldering points and everything seems to be ok.
I found that one of them was an unlocking attempt that went wrong, the customer tried to do it at home and removed the resistor from point A.
But I soldered a similar resistor to the point and it didn't work, could it be that having soldered a PTH resistor was the problem? I tried several ways and it didn't work. I always get the yellow blinking error *== (indicates error in CMD1).
The other consoles have the same *== error but still have their original resistors.
I've spent many hours on these 3 devices and haven't found any solution.
Has anyone been through this and can help me?
I did some research and didn't find anyone...
All 3 are unlocked but arrived with problems!
Two of them used HWFLY and it stopped working.
The third one used PICOFLY but it stopped working too.
They were all opened and I checked all the soldering points and everything seems to be ok.
I found that one of them was an unlocking attempt that went wrong, the customer tried to do it at home and removed the resistor from point A.
But I soldered a similar resistor to the point and it didn't work, could it be that having soldered a PTH resistor was the problem? I tried several ways and it didn't work. I always get the yellow blinking error *== (indicates error in CMD1).
The other consoles have the same *== error but still have their original resistors.
I've spent many hours on these 3 devices and haven't found any solution.
Has anyone been through this and can help me?
I did some research and didn't find anyone...