Not sure what to do next!

Discussion in '3DS - Flashcards & Custom Firmwares' started by Silentwidow, Oct 28, 2016.

  1. Silentwidow
    OP

    Silentwidow Newbie

    Newcomer
    2
    0
    Oct 28, 2016
    United States
    So I hardmodded my 3ds, I was able to get a nand.bin read, all that is done, I went through the autofirm guide here https://github.com/Plailect/Guide/wiki/Hardmod-Downgrade

    And I was able to flash the firmware. Now, I can't seem to figure out what to do next, most guides seem to be for the 3DSXL and not the new 3DS XL, which is what I have. I am showing on 11.1.0 -34u. Can anyone point me in the right direction?
     
  2. jayKeo

    jayKeo Member

    Newcomer
    31
    5
    Sep 13, 2016
    https://github.com/Plailect/Guide/wiki/Homebrew-Launcher-(No-Browser)
     
  3. x65943

    x65943 Resident Greekaboo, Amateur Dog Father

    Member
    2,452
    1,952
    Jun 23, 2014
    United States
    Indiana
    You should have installed the homebrew launcher if you followed that guide. @jayKeo posted the next part of the guide, which is linked to at the bottom of the page you provided (which just tells you how to install the homebrew launcher).

    At the bottom of that page is this https://github.com/Plailect/Guide/wiki/9.2.0-Downgrade which walks you through downgrading your device to 9.2. This is what you'll want to do next.
     
  4. Ar5chK3ks

    Ar5chK3ks GBAtemp Regular

    Member
    132
    14
    Mar 14, 2016
    Gambia, The
    Like stated above from @x65943 there are normaly links at the bottom of the guide pages which give you the next steps.
    Therefore just follow what they posted above and continue the guide.
    Sometimes there are different steps for different devices, but that is also described in the guide(e.g. After the "Decrypt9 Homebrew Launcher" section you have this Options:
    "If you are on Old 3DS, continue to 2.1.0 ctrtransfer

    If you are on New 3DS, reboot with (Start) and continue to Installing arm9loaderhax"
     
  5. Silentwidow
    OP

    Silentwidow Newbie

    Newcomer
    2
    0
    Oct 28, 2016
    United States
    I just needed Cubic Ninja :), luckily I had a job interview near fort mill SC, and they had a copy of it, I am fully hacked now, downgraded to 9.2, then followed the arm9 setup, and I have a fully modded one now, you guys are awesome, thanks for the help!
     
  6. Ar5chK3ks

    Ar5chK3ks GBAtemp Regular

    Member
    132
    14
    Mar 14, 2016
    Gambia, The
    Congratz and Good Job ^^
    Have fun and that's what this site is for :3
    Just one little advise at the end:
    If there is a new system version out, visit the forum again and look in the thread for the update, if Luma(or whatever you use) works fine with the new update or not.
    E.g.: A thread like this: http://gbatemp.net/threads/update-11-2-and-homebrew.446160/