Hi everyone. So I just had a Switch that would only boot using a computer in rcm mode. Well, thanks to the help of folks on this lovely forum, I was able to fix it. If you are curious on the first problem, here it is: https://gbatemp.net/threads/switch-...ormally-is-this-fixable.645093/#post-10319583
Anyway, I left it plugged into my computer for a few hours. The next morning, I went to try to use an emulator on it and the device cannot be detected in rcm mode. When I plug it into the computer and try the buttons, it only turns on normally. Anything I can do to get it to run in both rcm and stock? Thank you all.
Another thing that is happening is with the switch plugged into computer, even just holding plus (without power) will cause the switch to turn on. In stock only. Any suggestions?
Anyway, I left it plugged into my computer for a few hours. The next morning, I went to try to use an emulator on it and the device cannot be detected in rcm mode. When I plug it into the computer and try the buttons, it only turns on normally. Anything I can do to get it to run in both rcm and stock? Thank you all.
Post automatically merged:
Another thing that is happening is with the switch plugged into computer, even just holding plus (without power) will cause the switch to turn on. In stock only. Any suggestions?
Last edited by j4k0b7,