Hacking No power or light SX Core V1

[DragarX]

I've recently just finished installing an SX Core into my v1 switch it was going fine until the console crashed during an FTP transfer, after restarting and resuming the transfer, my switch turned off and now will not show any signs of life. After taking it apart again and cleaning up my solder points I was able to get it show the Nintendo logo for about 2 seconds and that's been it. I'm not sure what I could have done wrong for it to boot up fine for about an hour or so and then just die. I had it on charge the whole time during the transfer so I highly doubt it's a battery issue.

 

[Modi]

Try replace nand and check are this back to normal.

--------------------- MERGED ---------------------------

Try resoliding this point.Remeber use soldering flux and clean by IPA. Im new comer here but make some console

 

[AD2076]

It's beacause TX needs a jailbreak

 

[digipimp75]

Can I ask why you're modding a v1 with SX Core?

 

[Modi]

Can I ask why you're modding a v1 with SX Core?

I must be Patched Switches V1 if he use SX CORE

 

[Modi]

Mate try on OFW nand are thsi wotks fine in not check CAP on SOC.

 

[izy]

if thats your clean solder points
i hate to see what they looked like before

 

[Modi]

if thats your clean solder points
i hate to see what they looked like before

Hi mate hello from Poland . You not change

 

[izy]

Hi mate hello from Poland . You not change

jeth got a c and d nothing as serious as mine tho

 

[DragarX]

I've done this all without any kind of optical magnification. I re-flowed all the points and made sure they were clean and flat. I've reassembled the unit and it's now working without issues. Thanks to everyone for their suggestions.