Hi,
Posted this on reddit but got no response so i thought i'd try here!
I've got a nintendo switch v1 from ebay that was listed as faulty. It turns on and everything works, it charges (and fast charges) with the charger either way round, however after about 3 minutes of being on it throws up a black screen with error 2101-0001.
I know that usually this is the m92 or usb port, but this error normally comes up upon booting the console according to everything i've looked up, where as this one does it after 3 minutes.
It does this with and without an sd card in, and also does it regardles of the charger being plugged in or not. There are no shorts on the board, and as far as i can tell i'm the first person to open it up. I've used a jig to boot into hekate and backed up everything to the sd card (it didn't have any problems whilst doing this).
Is there anything else it could be or should i just swap out the port and m92?
Posted this on reddit but got no response so i thought i'd try here!
I've got a nintendo switch v1 from ebay that was listed as faulty. It turns on and everything works, it charges (and fast charges) with the charger either way round, however after about 3 minutes of being on it throws up a black screen with error 2101-0001.
I know that usually this is the m92 or usb port, but this error normally comes up upon booting the console according to everything i've looked up, where as this one does it after 3 minutes.
It does this with and without an sd card in, and also does it regardles of the charger being plugged in or not. There are no shorts on the board, and as far as i can tell i'm the first person to open it up. I've used a jig to boot into hekate and backed up everything to the sd card (it didn't have any problems whilst doing this).
Is there anything else it could be or should i just swap out the port and m92?
