Hacking I can't start my Switch as hacked

[Cyrsvn]

I had a chip installed in my oled switch a few weeks ago. The other day after I turned off the switch, instead of the hakate menu coming up when I turned it on, the chip lit up once blue and yellow and start switch non hack mod.
(I am a noob pls help.)

 

[Nephiel]

Count the yellow blinks and note if each is a long or short blink. It should be a pattern that repeats 3 times. It will help troubleshoot which error it is.

 

[linuxares]

https://gbatemp.net/download/a-definitive-picofly-install-guide.37968/

If you download this, you can check the error codes.
Here if you don't wanna download it, stolen directly from it.

On the other hand, if you didn't see Blue, White (SDloader Mem
write), then Yellow on your LED, and your console either boots
to a black screen, or instead boots to OFW like normal, then
look at the following LED code list to diagnose your potential
issue:
= is long Yellow pulse, * is short Yellow pulse:
= USB flashing done, * Successful glitch
** RST is not connected
*= CMD is not connected
=* D0 is not connected
== CLK is not connected
*** No eMMC CMD1 responce (bad eMMC?)
**= No eMMC block 1 read (should not happen)
*=* No eMMC block 0 read (eMMC init failure?)
*== No eMMC CMD1 request (poor wiring, or dead CPU)
=** eMMC init failure during glitch process
=*= CPU never reach BCT check, should not happen
==* CPU always reach BCT check (no glitch reaction, check
mosfet)
=== Glitch attempt limit reached, cannot glitch
=*** eMMC init failure
=**= eMMC write failure - comparison failed
=*=* eMMC write failure - write failed
=*== eMMC test failure - read failed
==** eMMC read failed during firmware update
==*= BCT copy failed - write failure
===* BCT copy failed - comparison failure
==== BCT copy failed - read failure