Homebrew Homebrew Channel and External Hard Drive

[DarkSunDS]

My hard drive is set up in a somewhat weird way. In order to run USB Loader GX without an SD card, I have one NTSC partition for my personal files, a WBFS partition for the USB loader, and a FAT32 partition for homebrew. Said homebrew is detected properly on USB Loader GX, but in the homebrew channel, nope. After a while (I don't know what triggers it), no homebrew application is detected in the homebrew channel. I tried launching the Homebrew Browser in USB Loader GX, and it updated itself. Then it showed up in the homebrew channel. But even the application doesn't detect other homebrew that USB Loader GX identifies perfectly fine.

I don't have an SD card inserted in the slot, no.
I tried using both USB ports.

Is it possible that the homebrew channel is confusing the NTSC and FAT32 partitions or something?

 

[flotwig]

Do you use the Wii's USB ports to charge anything (iPod, Wiimotes, etc.)?

 

[DarkSunDS]

No, the only thing that's plugged in is the hard drive.

 

[Screemer]

ntsc != ntfs...

 

[DarkSunDS]

ntsc != ntfs...

I don't think you get it.

 

[Senbonzaku101]

Perhaps your hard drive times out after not being accessed?

 

[m00k]

I have the same issue
hard drive installed = 10gig fat32 partition + 100gig wbfs partition

Fat32 recognised in :-

mplayer ce
wiixplorer
gui wadmanager (if plugged into the other usb port)
Geexbox (obviously)

Fat32 not recognized in :-

Homebrew channel
ftpii (fails to mount)
wani's wad manager 1.5 (mounting ret= -1) no matter what ios used to load 249, 223, 222, 202.

Mplayerce usb tester says my hard drive is fully compatible.

Other usb test program log:-

USB2 device test program. v1.0
------------------------------
usbstorage init
status1: 0x1803
status2: 0x1101
port reseted status(0): 0x1005
getting USB_REQ_GETDESCRIPTOR
USB_REQ_GETDESCRIPTOR ok
trying USB_REQ_SETADDRESS: 2
USB_REQ_SETADDRESS ok: 2
checking USB_REQ_GETDESCRIPTOR
ok checking USB_REQ_GETDESCRIPTOR
init ok
USBStorage_Open
USB_GetDescriptors
USB_GetDescriptors ok
USBStorage_Open(): interface subclass 6 ata_prot 1
USB_GetConfiguration ok
USB_SetConfiguration ok
interface: 0
altInterface: 0
USBStorage_Open ok
USBGetMaxLun ok: 1
SCSI_TEST_UNIT_READY ok, status: 0
SCSI_INQUIRY ok
USBStorage_ReadCapacity ok

mounted ok, lun: 0

begin to load sector 1
sector 1 read ok

DEVICE 100% COMPATIBLE!!!

Ive installed usb cios to all possible ios, i've also used any title deleter to dealate them and then reinstalled them all again! Is there anything else i can try to get homebrew loading from the usb hard drive fat32 partition? Or am i to be left a broken man