Hello,
I’ve been trying to hack my switch for the last 2 days now. Once I finally got the homebrew and everything on, I realised that my sysnand was sharing the same storage as the emunand. So back to the drawing board I had to do it all again and then realised that the emunand can only be around 29GB. So I made a partition on minitool wizard for 29GB and both of the partitions were formatted in fat32.
I put it into the switch and it didn’t recognise the partition and asked to create one with the hekate partitioning instead. I have had issues with the hekate partitioning before because it doesn’t format them in fat32 so when I try to enter cfw it says “failed to run sept”.
Either way I cleared all the partitions yet again and this time just loaded into hekate and let it make the partition itself. After waiting to no surprise I get the same “failed to run sept” error because the partition is not fat32. I don’t know how to do this properly, can someone help? No matter what I do something always goes wrong.
I’ve been trying to hack my switch for the last 2 days now. Once I finally got the homebrew and everything on, I realised that my sysnand was sharing the same storage as the emunand. So back to the drawing board I had to do it all again and then realised that the emunand can only be around 29GB. So I made a partition on minitool wizard for 29GB and both of the partitions were formatted in fat32.
I put it into the switch and it didn’t recognise the partition and asked to create one with the hekate partitioning instead. I have had issues with the hekate partitioning before because it doesn’t format them in fat32 so when I try to enter cfw it says “failed to run sept”.
Either way I cleared all the partitions yet again and this time just loaded into hekate and let it make the partition itself. After waiting to no surprise I get the same “failed to run sept” error because the partition is not fat32. I don’t know how to do this properly, can someone help? No matter what I do something always goes wrong.