Hacking Help required with DSiware Injection

[KVS]

Hi,
I have nintendo 3dsxl running CFW and i would like to put CFW on another nintendo 2ds running stock 11.5.0-38u
Followed the guide as outlined in 3ds.guide with the Dsiware injection method. I have purchased the dsiware "Faceez! Monsters" in source device and followed the guide.
During the step 28 in Section II, while launching the game, i dont get any error.
The sudoku game runs perfectly fine. The guide says "if your game behaves normally and does not give you an error about boot.nds, then you should stop and figure out what went wrong"
Im not able to figure out what's going wrong. I have tried the steps once again as well after deleting the Dsiware and redownloading it.
Same condition persists..

seeking help here as im stuck....

Regards
KVS

 

[einhuman197]

Looks like it's works for me. Just continue the guide.

 

[KVS]

Thanks. Can i proceed further even though i dont get any error(as outlined in the guide) while launching the injected game..? Pls clarify..

 

[Cuphat]

If Sudoku runs without crashing, that means you did not inject the save properly. Try again (Section II, steps 13 - 26 cover injecting the save). The FAT image should just be one file (savedata.bin) with no directories, so make sure you are copying the right thing.

This is what it looks like when you successfully injected the save, after starting the game and tapping the screen on the title screen:

 

[KVS]

Thank you for your reply... I have followed those steps carefully. The only difference is that the Savedata folder that i have dont have a second savedata folder in it. So i just copy the first savedata folder which has the savedata.bin to the fat image in step 23. i have tried redownloading the sudokuhax torrent and still see only one savedata folder in the torrent. This is the only difference that i encounter while carrying out the steps 13-26..

--------------------- MERGED ---------------------------

Repeated the steps and ignored to copy the savedata folder and i have copied only the savedata.bin as you have mentioned. It now works fine. I get the same screen as you have shown.. .Thanks a ton.... will proceed further...
Thank you so much for your help.....