Hekate reports SD Reader is in 1 bit mode

[smoere]

It started with this message coming in on some boots. Just after a few new inserts of the SD it now shows up everytime.
Therefore i assume the the problem is hopefully somewhere in the reader or at a directly attached part of the reader unit.
I have already had a look at the reader and the pins of the connector but visually everything looks fine.

I have ordered a new reader unit now. I hope problem will be fixed by that.
I ordered the new reader at Amazon being labeled "Amonida SD Reader". So probably not original. But i guess it does not matter much.....

Any ideas?

 

[Hayato213]

Either it is your flex or your SD card connector on the board.

 

[smoere]

I am praying. If it is the connector i am fucked. I dont have the capabilities to solder something like that.

 

[smoere]

My prayers were heard!
Switch works like a charm with the new reader. Topic closed