Hacking D2E - Red Light - Drive just makes noise

[djcraze]

Hello everyone, my friend just bought the D2Pro for his D2E chip with the WiiClip.. He installed it, but he just gets a red light on the D2E and the drive just makes a clicking noise with a disk out... When he puts a disk in, the disk starts to inch while the ModChip is still lit with a Red LED. When the disk is finally in, it never gets read by the Wii.

Any ideas? Faulty ModChip? New firmware for this perhaps?


Thanks,
DJ

 

[NeSchn]

Its the classic inching problem. The new update solves the problem.

 

[djcraze]

Is D2Prog needed to do this update?


Just read it does. Thanks for the help

.


Edit
Hmm actually what I read says only up to D2C2.. sooo What?

 

[linuxares]

Does D2Pro have support for D2E yet?

 

[ModchipCentral]

Is D2Prog needed to do this update?


Just read it does. Thanks for the help

.


Edit
Hmm actually what I read says only up to D2C2.. sooo What?

If he has the D2E chipset, I can guarantee you the inching problem will be solved if he removes the CLK jumper and solders the J wire manually as shown here: http://www.wii-clip.com/V4B_for_D2pro-9.htm

 

[Richy Freeway]

If he has the D2E chipset, I can guarantee you the inching problem will be solved if he removes the CLK jumper and solders the J wire manually as shown here: http://www.wii-clip.com/V4B_for_D2pro-9.htm

That's exactly what I wanted to know! Thanks for answering my question before I asked and for the speedy delivery & service.

 

[djcraze]

Is D2Prog needed to do this update?


Just read it does. Thanks for the help

.


Edit
Hmm actually what I read says only up to D2C2.. sooo What?

If he has the D2E chipset, I can guarantee you the inching problem will be solved if he removes the CLK jumper and solders the J wire manually as shown here: http://www.wii-clip.com/V4B_for_D2pro-9.htm

Ok, thanks! I'll pass the information off.

 

[Richy Freeway]

Problem solved. Working perfectly now.