Ok so i was trying to install a CFW to my friends standard O3ds and i just couldn't. i used my gateway to set him up and the gateway mset works fine and i setup a emunand and all but if i install a cfw like rxtools or reinand i get little errors. i first tried installing rxtools 2.6 (mset) installed the mset and it loaded up to the menu, BUT when i tried to press load into emunand or sysnand it said some kinda error, i think something to do with the firmware.bin. so i gave him my firmware.bin from my N3ds reinand setup (i was told it is all the same firmware.bin) and put it in the sd root and also in the rxtools/sys just to be safe.. so the sd setup looks something like this (based on my memory) =========== Root:/ rxtools(folder) rxtools.dat firmware.bin ========= Root:/rxtools/ sys(folder) *other folders* =========== Root:/rxtools/sys code.bin firmware.bin *other bin files* =========== now i placed the firmware.bin multiple times because im not sure where it goes, some say rxtools/sys for the new one and some say root of SD card now as the ending result is that i tried both rxtools 2.6 and a nightly ver 3.0 and as for 2.6 when i placed the firmware.bin in some places that when i tried to launch rxtools 2.6 it just freezes on the setting up files screen "this should not more then a a minute" it hard freezes. then i try to install the rxtools 3.0 but the multi ROP installer that came with the tool, none of the mset options there work. some say 4.x rxtools some say 4.x DG rxtools, and all that other stuff installing any of them result in the settings app crashing back to the sysnand home menu. is it because its 4.3 and and not 4.5?