CLK Point Exposure on Switch OLED.

[Gimer]

I have exposed the CLK point on my Switch OLED, and it boots to OFW perfectly fine. I want to do a continuity test and was wondering where I should place my probes. And if the continuity is good, would I be good to go ahead and solder or is there anything else I should check before hand?

 

[jkyoho]

want to do a continuity test and was wondering where I should place my probes.

You meant diode reading test I believe. You put red prob in any ground(like the metal shield on port or CPU bracket) and black prob on the point you want to test.

 

[Gimer]

You meant diode reading test I believe. You put red prob in any ground(like the metal shield on port or CPU bracket) and black prob on the point you want to test.

What are the readings we want?

 

[jkyoho]

can't remember clk but shou be around 0.4xx to 0.7xx