Homebrew 1152i When Loading 1080i Swiss

[Archerg]

Hey everyone, I seem to be having a rather niche issue using the official component cables on my PAL GameCube, I'm trying to force games to utilize the 1080i setting on Swiss. Now, I'm loading this for games that run at 60fps of course, such as Melee and Paper Mario TTYD, but the system just boots into 1152i, or doubled PAL 576p. I'm unsure what I'm doing wrong with the Swiss settings. To walk you through my methods, AVE compatibility is set to CMPV-DOL, Force video mode is 1080i60, Swiss runs at 480p. I'm using a memory card exploit with ShineHax (Super Mario Sunshine) and loading Gekkoboot to the Swiss file on my slot B SD card. Oh, and I'm running the component cables through an OSSC, though I'm unable to try either passthrough or bob deinterlacing as the OSSC wont display that resolution, with only a black screen being shown and the resolution listed on the display.

Any help would be instrumental.

 

[Extrems]

1080i has 1125 total lines, which is what the OSSC reports, as it similarly does for 480p (525 lines).

 

[Archerg]

@Extrems Oh I see! I must have read that wrong on the display and went a bit on some mental hoop jumping. Hm, apparently I am the fool for not attempting simply passthrough, and this works fine. From what my TV can decode, the image looks slightly better in 480p, though I am unable to to get the ossc to bob deinterlace that signal, and just shows the black screen. Is there a specific setting for it, or should I just let my TV handle that one?