Recent content by Mocho

  1. Mocho

    PS4 Fan issue? (Fat model)

    Thanks, checking now failure one is 1200 series, other 1100, must be for that.
  2. Mocho

    PS4 Fan issue? (Fat model)

    Cleaned and thermal paste replaced at fan time replaced, anyway just seconds after boot up turn off, without put any game turns off, suppose must be by the fan
  3. Mocho

    PS4 Fan issue? (Fat model)

    Hi, I have confussion about how fan should work and if is the real issue. My PS4 starts to be overheated, sound 3 beep and turns off, realized fan wasn't working. At power it on time, do some spins and stop, should be spinning always or just when need be cooled?. Tried other fan from other PS4...
  4. Mocho

    Switch No Wi-Fi BT either after disassembly

    That was the solution for mine, just removing the diode
  5. Mocho

    Switch No Wi-Fi BT either after disassembly

    Looks the solution for the fan and joycons charge in first model motherboard only, the diode
  6. Mocho

    Switch No Wi-Fi BT either after disassembly

    Same case, probably have a luck, will comment it
  7. Mocho

    Switch No Wi-Fi BT either after disassembly

    The Wi-Fi was the missing resistor or capacitor, solved putting from a doner board. But controllers still not responsing at all. Is weird. If plugged the genuine joycons didn't work if not charged (so not charging). Charged in other switch then recognized (so BT is working). If plugged non...
  8. Mocho

    Switch No Wi-Fi BT either after disassembly

    https://gbatemp.net/threads/nintendo-switch-wifi-dead-but-bluetooth-works.592368/ Found it searching in the forum, not looks like 100% of my case, coz mine haven't BT as well, tomorrow will check it the board again properly
  9. Mocho

    Switch No Wi-Fi BT either after disassembly

    Coax connector are right connected. Seater property what you mean?, the case?
  10. Mocho

    Switch No Wi-Fi BT either after disassembly

    Yeah, checked it, are properly connected :(
  11. Mocho

    Switch No Wi-Fi BT either after disassembly

    I commented checked the coaxial cables. Didn't unplugged by what I did, anyway I checked if unfortunately disconnected but wasn't. Anyway if were disconnected if palced close to the router, wi-fi signal shown but low, right? Is like not wi-fi at all, either the controllers. Something I'm...
  12. Mocho

    Switch No Wi-Fi BT either after disassembly

    I had disssembly my son Switch for dust cleaning (playing saying too hot ant shut down). After reassemble it no Wi-Fi detected and controllers didn't recognized. I suppose is up to this module because normalli Wi-Fi and BT is in the same chip. Coaxial lead is connected. What else shall I check?
  13. Mocho

    Hardware Blue screen, hardware issue

    Hi, I have a switch had impact and so on blended, now screen in blue, disassembled it and check with microscope nothing physically looks bad, so I suppose is below an IC. Any schematic to check voltages or in resistance mode on different lines?
  14. Mocho

    Hardware Nintendo Switch motherboard losing a component

    At the end take one of this coil from a mobile phone with same value. After solder it and assembly the switch connect the power lead, show the icon battery but then black screen an the fun start working at high revolutions. Not sure if that coil/circuit is the culprit, anybody know whats about...
  15. Mocho

    Hardware LCD FPC Connector for Nintendo Switch

    Up to the plastic of the connector better use low temperature solder paste
See more
General chit-chat
Help Users
    MrNoobNub @ MrNoobNub: why is everyone so horny