Recent content by FiXiNGA

  1. FiXiNGA

    Switch fries M92T36 after swap

    I hoped this also and used one from a donor (where everythin worked) and also it burned the same way. I measured all mosfets around and all Are good.
  2. FiXiNGA

    Switch fries M92T36 after swap

    Swapped with a new one already and measured with diode readings. Everything good.
  3. FiXiNGA

    Switch fries M92T36 after swap

    Thanks so far. Regarding battery: the M92 fried without a battery connected. Just the Mainboard connected to the charger for testing general behaviour.
  4. FiXiNGA

    Switch fries M92T36 after swap

    Hi there, I have a Switch here which came with Error 2101-0001. On top of M92 there where two shorted caps so I swapped the M92T36 with a new one. Everything measured Fine but after plugging in the Nintendo Charger the M92 got fried and the shorts Are again at the same caps. So I tried to...
  5. FiXiNGA

    PS5 is working normaly and then shuts down EDM-010

    Measure all caps and mosfets one by one with diode mode. All of em should have nearly same values. In best case you have a working donor board on the side to verify your readings. If then a reading is suspicious dig deeper into. If it is Short you should inject voltage and observe the board with...
  6. FiXiNGA

    PS5 Single Beep BLOD UART Code unknown

    I made some other repairs before but today came back to it. After swapping RAM#5 with a donor one the console came back to life!! Thank you so much, I do Not know on how to have this been documented in the UART lists. I m using CST and dont know where the descriptions of failures are stored...
  7. FiXiNGA

    PS5 Single Beep BLOD UART Code unknown

    Hi, I have a PS5 on my bench with single beep BLOD. It flashes blue light for around 3s and then goes off. Second try is beep only (Init phase only). Then third again 3s. All fuses are good. Init phase is 311mA then 7mA. Good so far. Thermal cam Shows every relevant component flashes warm and...
  8. FiXiNGA

    PS5 is working normaly and then shuts down EDM-010

    Thanks a lot! You are very helpful! 1721301817 Update from today: - I removed the thermal putty and made diode readings of all regulators - number three counted from bottom had one reading which differs from the others - I removed the regulator and still reading was bad - On the other side of...
  9. FiXiNGA

    PS5 is working normaly and then shuts down EDM-010

    Thanks a lot. Are those stages on the RAM or APU side? 3 of em are getting hot on the thermal cam. I was also thinking on that, like voltage is not stable and then a shutdown occurs. So you think about reading diode measurements around the mosfets?
  10. FiXiNGA

    PS5 is working normaly and then shuts down EDM-010

    My feeling is a bad RAM or APU. But I‘m not sure if it is worth the time to swap all RAM modules based on feelings
  11. FiXiNGA

    PS5 is working normaly and then shuts down EDM-010

    Hi all, I have a PlayStation 5 on my bench where you can play games normally for some time. After 10-15 Minuten the console shuts down immidiately. Without FAN it crashes a bit faster, I was switching from game to menu and back for many times. After clearing the errlog and crashing I have the...
  12. FiXiNGA

    PS5 EDM 020 TPM Issue

    No not yet. It was soo time consumption that I stopped working on it. At the end the SB was soldered and reballed 3-4 times by me and that was many work. It is a donor now.
  13. FiXiNGA

    XBOX One S Power On and then Off Q9F2

    Okay I have some news but not finished the console. It was a failure of the mosfet Driver for MemIO. I measured the ground but did not know it before having the circuit diagrams. So I swapped the mosfet driver and the memory now getting 1.5V But now the console beeps, light is flashing, NO...
  14. FiXiNGA

    XBOX One S Power On and then Off Q9F2

    Hi, I have a XBOX One S which is beeping, shortly white light and then goes off. I measured all mosfets and observed that the Q9F2 Drain side is deadly shorted. By injecting 2 Amps nothing getting warm. I already pulled the two caps near to Q9F1 and Q9F2 but still shorted. Do you know what...
  15. FiXiNGA

    PS5 interchangeable ram moduls from EDM-010 to EDM-020?

    thanks a lot. So it is a BGA180, as the one you have linked is not available any more I ordered the same from another shop.
See more