Gaming Doom Eternal "software closed because an error occurred"

[Levente]

I am on 10.0.4 FW and AMS 0.13.0 - Base, Update and DLC Installed. No Issues except I can not get the Rip and Tear Pack to come up.

Any solution to get the Rip and tear dlc to work?

 

[FanNintendo]

same here i think the update is supposely be 12.0.1 and on goldleaf it says 11 generation key (10.0.0) maybe the key is fake and Im on 11.0.1 with 1.9.5 atmosphere i might update to 12.1.0 later to see if it wil work

 

[adda]

Be very careful when updating firmware. If you are on sxos, you anything above 11 will not be compatible, and cause a problem. also do not use choix du jour!

 

[FanNintendo]

not on sxos. also i tried use SAK Swiss Army Knife to lower the Doom Eternal require firmware and it not working before i update.Now im not bothering Doom Eternal until new updates comes if there will be

 

[mathew77]

Can't find a way to run DLC Rip & Tear properly on a CFW, unfortunately.

 

[BigOnYa]

Can't find a way to run DLC Rip & Tear properly on a CFW, unfortunately.

Update FW, only choice. I'm on 13.1 and all is working well.

 

[mathew77]

Update FW, only choice. I'm on 13.1 and all is working well.

Yep, I'm at 13.2.0 @ AMS 1.2.5, tyvm.

Did you try DLC Rip & Tear, that one DLC? 'cause the game tells me I haven't any master levels, but all the DLCs are successfully installed.

 

[BigOnYa]

Yep, I'm at 13.2.0 @ AMS 1.2.5, tyvm.

Did you try DLC Rip & Tear, that one DLC? 'cause the game tells me I haven't any master levels, but all the DLCs are successfully installed.

Yea fine for me...make sure you installed the right region of all DLC and updates as your base game. Must be the same Build ID.